Irrigation · Nashville, TN
Irrigation in Gallatin, TN
Gallatin irrigation contractors for new sprinkler systems, sprinkler repair, controllers & smart watering and more. Systems designed by zone, backflow tested and certified, a written price for the whole yard, across Sumner County and the rest of Middle Tennessee.
Estimate request
What is the sprinkler system doing, or not doing?
Straight to us, and a reply the same day.
Gallatin lots, soil and slopes: what they mean for sprinklers
Older lots have mature trees whose roots are in the way of every trench and whose shade changes the zones; the design routes around the roots and waters the shade lightly.
The house and its hardscape — the drive, the patio, the beds against the foundation — set where the heads go and what they must not water.
New subdivisions were sodded on graded clay, and the irrigation the builder installed — if any — was the minimum; a redesign by zone is often the difference between sod that lives and sod that does not.
Lakeside lots sometimes draw irrigation water from the lake with a pump, which is a different system with its own filtration and rules; the contractor should know both.
On a sloped yard the water runs downhill before it soaks in, and the zones on the slope are run in short cycles; the low corner gets less water than the controller thinks.
Gallatin at a glance
Irrigation work around this town
Housing stock
Historic core plus heavy 2005 onward
County
Sumner County
Ground conditions
Rolling clay; Old Hickory Lake on the southern edge
Permits issued by
City of Gallatin Codes and Building
In and around Gallatin:
- Downtown Gallatin
- Fairvue Plantation
- Foxland Harbor
- Cambridge Farms
- Station Camp
Services
Sprinkler and drainage service in Gallatin
New Sprinkler Systems
Designed zone by zone for head-to-head coverage, your water pressure and the way your yard actually drains.
Learn moreSprinkler Repair
Broken heads, cut lines, stuck valves, wiring faults and the dry patches that are really coverage problems.
Learn moreControllers & Smart Watering
Weather-based controllers programmed for Tennessee seasons instead of the factory default that waters daily.
Learn moreBackflow Testing & Certification
Annual testing and certification, which most Middle Tennessee utilities require on any irrigation connection.
Learn moreDrainage & French Drains
Yard drains, French drains, downspout tie-ins and regrading for ground that holds water or sends it at the house.
Learn moreWinterization & Spring Start-Up
Blow-outs before the first hard freeze and a full system check and adjustment when it comes back on.
Learn moreWhy homeowners here call
Why Gallatin yards need us
Watering correctly in Middle Tennessee means deeply and infrequently, and almost every controller left on its factory program does the opposite. Short daily cycles grow a shallow root system that cannot survive an August here, while two or three longer soakings a week drive roots down to where the moisture stays. The controller setting matters more to how a lawn survives summer than the system design does.
- A water bill that jumped with no change in habits
- One zone that has stopped coming on at all
- Heads that have sunk below grade or been clipped by a mower
- A system that has never been winterized before a hard freeze
Spacing heads to the edge of their throw. Sprinkler output falls off toward the edge of the arc. Heads have to overlap head-to-head or you get rings of dry grass.
Nearby
Neighboring towns we cover
FAQ
Irrigation in Gallatin: common questions
Do you cover Gallatin, TN?
Yes. Our irrigation technicians cover Gallatin and all of Sumner County, with Hendersonville, Mt. Juliet, Lebanon, Nashville inside the same routes.
How much does irrigation cost in Gallatin?
Irrigation in Gallatin is priced by the zone for a new system — the heads, the valves and the pipe for each — plus the controller and the backflow; a repair is priced by the part and the hour, and the leak is found before the part is named. The house and its hardscape — the drive, the patio, the beds against the foundation — set where the heads go and what they must not water.
Who issues permits for irrigation in Gallatin?
City of Gallatin Codes and Building and the water utility require a backflow preventer on every irrigation system and an annual test by a certified tester; the paperwork goes to the utility, and the technician files it.
How quickly can you get to Gallatin?
A broken head or a zone that will not shut off in Gallatin is seen within a day or two; a new system is designed within the week and installed in a few days once the utility locates are in.
What areas around Gallatin do you serve?
Irrigation technicians serving Gallatin also cover Hendersonville, Mt. Juliet, Lebanon, Nashville; the routes run through 65 towns in 12 counties.
Free estimate
Fix the sprinklers at your Gallatin home
Explain what the Gallatin system is doing and Nashville's Irrigation replies with a free written estimate covering heads, zones and any backflow testing it needs.